URL: https://www.softwarespecialties.com/cgi-bin/rpgforum/dcboard.cgi
Forum: DCForumID19
Thread Number: 2025
[ Go back to previous page ]
Original Message
"umpani machine"
Posted by tbird1000 on Mar-05-03 at 12:29 PM
I get to the point in mt gigas where you come to that machine that opens the doors to the gunnery. I use my level 3 security pass, and the machine breaks down, just like it's suppose to. So I fix the wires, and use my pass again...I get the same message, and the doors don't open (but the wires are still connected). Am I missing something? did I do it wrong? Please help!
Table of contents
Messages in this discussion
"RE: umpani machine"
Posted by gator on Mar-05-03 at 12:35 PM
Did reconnect all three wires (green, blue and white)? The first time I tried this, I had thought that the white wire did not need reconnecting.
"RE: umpani machine"
Posted by tbird1000 on Mar-05-03 at 12:39 PM
ahah! Yeah it was the white wire. I didn't even see that it was disconnected. Thank you
"RE: umpani machine"
Posted by Stefan on Mar-06-03 at 02:16 AM
Sorry but I went to that machine and it break down as well, but I could nit discouver any wire to fix. I checked all sides of the machine. Is there a trick or is that a buck ?

Stefan

"RE: umpani machine"
Posted by tbird1000 on Mar-06-03 at 07:26 AM
the white wire connects at the bottom of the pannel, not the top, it's kinda hard to see.
"Not a bug"
Posted by Llevram on Mar-06-03 at 07:54 AM
LAST EDITED ON Mar-06-03 AT 07:54 AM (Pacific)

When it breaks, the panel falls off the back. Go around back and touch the wires. If you touch the right one, it reconnects. If you touch the wrong one, it shocks you. With a bit of trial and error, you can get all three reconnected ... then use the machine again.

Tools for Wizardry(r) 7